Ours is the Ninja DualBrew Pro (CFP301) — the black machine with the glass carafe and the water tank on the right.
It brews from ground coffee (a mug or the full 12-cup carafe) or from a K-Cup pod, single serve.
Four brew styles: Classic, Rich, Over Ice and Specialty.
Ground coffee
- Slide the lid back under the hood, set the permanent filter in the brew basket, add grounds. The Ninja Smart Scoop in the drawer carries the measure for each size.
- Turn the Multi-Serve dial to the size: Sm Cup, Cup, XL Cup, Travel, XL Travel, or 1/4 · 1/2 · 3/4 · Full Carafe.
- Press START BREW. A short pause after it starts is the machine pre-wetting the grounds — leave it alone.
K-Cup pods
- Slide the lid back. The Pod Adapter sits over the brew basket and comes already installed.
- Lift the adapter handle, drop the pod in, press it down to LOCK, then slide the lid closed until it clicks.
- Pod sizes are 6, 8, 10 or 12 oz — turn the dial, then START BREW.
Brew styles
- BREW STYLE cycles Classic → Rich → Over Ice → Specialty.
- Over Ice: fill the cup to the top with ice first, then choose Over Ice. Plastic or the Ninja glass carafe only — no other glassware.
- Specialty: a ~4 oz concentrate for lattes and cappuccinos. There's no size to pick — it always makes 4 oz.
Keeping it warm, and Delay
- The warming plate holds a 1/4, 1/2, 3/4 or full carafe for up to 4 hours, on Classic and Rich only. Press KEEP WARM to switch it off.
- Delay: press DELAY, set the hour with the dial, START BREW to move to minutes, set those, then pick the size and style.
- Drip stop: the lever at the basket. Close it to pull a cup mid-brew or stop the last drips, then open it again before the next brew.
Hot water and the frother
- Hot water for tea or instant soup: turn the dial on the left side to the water-droplet icon. It's a separate water line, so there's no coffee taste.
- Frother: a fold-away whisk on the left. Milk about a third of the cup — microwave 45–60 seconds first if you want hot froth — hold the cup so the whisk sits just under the surface, froth 30–45 seconds. It froths, it doesn't heat.
Clock, cleaning, and the light you shouldn't ignore
- Clock: press HR/MIN, turn the dial to the hour, START BREW to jump to minutes, turn to the minute, START BREW to set.
- CLEAN light means the machine wants a descale. That's a between-guests job — message Greg and he'll take care of it.
- The water tank lifts off the right side for refilling and washing. Some water stays in it after a brew; that's normal.